Instructor Led Explained Training in Canada

Power Generation - Gas Turbines, Co-Generation, and Combined Cycle Plants, Wind Power Generation, and Solar Power ...ed cycles plants during the last two decades will also be explained. This seminar provides also indepth computer simulation of gas turbines under steady-state and transient conditions. The analysis performed by gas turbine simulators provides the following benefits: 1. Allow the operator to extend the gas turbine operating period by avoiding unnecessary outages and maintenance activities  more...

Structural Design Step by Step Workshop Description This course is a practical structural design course that contains step-by-step procedures to help understanding and solving routine structural problems. The course contains a short introduction to the National Building Code of Canada, NBCC 2005, and then goes into details on how to calculate the expected loads on different structures, which include dead, live, snow, wind, seismic and  more...

Power Generation - Gas Turbines Co-Generation and Combined Cycle Plants Wind Power Generation and Solar Power ...ed cycles plants during the last two decades will also be explained. This seminar provides also indepth computer simulation of gas turbines under steady-state and transient conditions. The analysis performed by gas turbine simulators provides the following benefits: 1. Allow the operator to extend the gas turbine operating period by avoiding unnecessary outages and maintenance activities  more...

Power Generation Gas Turbines Co-Generation and Combined Cycle Plants 30 CEUs This seminar provides a thorough understanding of co-generation and combined cycle plants. Each of the components such as compressors, gas and steam turbines, heat recovery steam generators, deaerators, condensers, lubricating systems, instrumentation, control systems, transformers, and generators are covered in detail. The selection considerations, operation, maintenance and economics of  more...

Mill Level 1 Applications MasterCAM 3X 4 days In level 1, the student will begin with navigating the MasterCAM interface. The different geometry tools is explained. Also, the student is shown how to modify geometry after it's created. Later, the different machining operations are discussed.  more...