|
Provided by: 123-CBT Computer Based Training NetWare Service and Support Upgrade - Part 2 |
 |
Course Overview
This course is the second in a five-part series on Novell NetWare Service and Support. This series focuses on the prevention, diagnosis, and resolution of hardware-related problems that network professionals encounter while working with a network. This course will cover installing, configuring, and troubleshooting various types of networks and network storage devices.
Learn To:
- Install, configure and troubleshoot various types of networks.
- Install and troubleshoot network storage devices.
Content Emphasis
Skills-Based
Audience
Students should be CNE candidates or technical support personnel responsible for diagnosing and resolving problems with NetWare networks. Participants should have an understanding of (or experience with) personal computers, operating systems, and network technology; experience with DOS; a working knowledge of Windows 95 or Windows NT Workstation; and experience using NetWare. In addition, students should have taken the first part of this series (course 82211). This course series is an approved study guide that will help certification candidates prepare for exam 50-635 and is equivalent to Novell class 580.
Total Learning Time
6 - 8 Hour(s)
Course Contents
Unit 1: Working With Networks
Duration: 3 - 4 Hour(s)- Identify the characteristics of a Token Ring network.
- Identify the sequence of activities depicting the working of a Token ring network.
- Match the components of a typical Token Ring Network with their features.
- Identify the limitations of Token ring cabling.
- Identify the sequence of steps involved in installing a token ring connection.
- Identify the steps taken to correct problems in a Token Ring Network.
- Select the characteristics of an Ethernet network.
- Identify the activities involved in the working of an Ethernet network.
- Identify the sequence of steps involved in installing an Ethernet Connection.
- Identify the steps to be taken to troubleshoot an Ethernet connection.
- Identify the characteristics of a Fiber Distributed Data Interface (FDDI) network.
- Identify the steps involved in the working of an FDDI network.
- Identify the steps involved in troubleshooting an FDDI network.
- Identify the characteristics of an Asynchronous Transfer Mode (ATM) network.
- Identify the steps to connect an Ethernet network to the other networks.
- Identify the steps to connect a Token Ring with other networks.
Unit 2: Network Storage Devices
Duration: 3 - 4 Hour(s)- Match hard disk components with their functions.
- Identify the differences between the features of the two Integrated Drive Electronics (IDE) versions.
- Identify the limitations of IDE in NetWare.
- Identify the features of three Small Computer System Interface (SCSI) versions.
- Identify the guidelines for installing hard disks.
- Sequence the steps to setup a SCSI disk.
- Identify the methods used for termination based on the placement of the SCSI disks.
- Identify the guidelines for working with SCSI cables.
- Sequence the steps to physically install an IDE disk.
- Identify the jumpers that are set to configure a controller board.
- Identify the situations in which an IDE disk is configured in a specified mode.
- Identify the guidelines to attach a cable from an IDE controller board to an IDE disk.
- Identify the steps involved in setting the Complementary Metal-Oxide Semiconductor (CMOS) disk type for an IDE disk.
- Identify the situations when a low-level format is performed.
- Create an active DOS partition by using a DOS boot diskette.
- Identif
This is primarily online training 
This is an online eLearning or CBT training program 
This program may be available on CD 
Contact 123-CBT Computer Based Training for more information Training Presented in: English
