California-OSHA Electrical Safety

This course provides an overview of basic electrical safety for individuals with little or limited training or familiarity with electrical hazards and is designed for any worker who may use extension cords, electric tools, etc. This course covers the topics included in OSHA 29 CFR 1910. 301-399 Subpart S.
LEARNING OBJECTIVES:
Establish the conditions covered by OSHA s 1910 Subpart S Design Safety Standards
Outline the general requirements for electrical safety standards
Understand the proper use and identification of circuits and conductors
Define the standards for electrical grounding and protection
Establish the general requirements for wiring methods and equipment
Establish the guidelines and requirements for special purpose equipment
TOPICS COVERED:
Lesson 1 Introduction to Electrical Safety
Lesson 2 Wiring Design and Protection
Lesson 3 Wiring Methods, Components, and Equipment
Lesson 4 Specific Purpose Equipment
REGULATORY REQUIREMENT:
Please see the state/ regulatory requirement from the course catalog page.
SEAT TIME:
This course has been approved for 1 hour.
COURSE PRE-REQUISITE:
N/ A
TESTING:
Quizzes - All quizzes must be passed with a 100 to proceed forward to the next lesson.
Final Exam- Final Exam must be passed with a 70 to pass the course. The final exam can be taken three times if necessary.